Pre-orders open · Release Nov 30 · Ships from Dec 15 Code BELIEVE for 30% off gear Shop now →
Support / Firmware / Flash over USB
Firmware · backup

Flash over USB

If a WiFi update won't go through, or the app says a box's firmware is too old to update, install the latest firmware from this page with the box plugged into a computer.

You need

  • A computer (Windows, Mac, Linux or Chromebook) with Chrome or Edge. Phones, iPads, Safari and Firefox can't do this.
  • The USB-C cable from the box (a charge-only cable won't work).
  • Internet on the computer while you flash.

Install

  1. Plug the relay or hub into the computer with the USB-C cable.
  2. Click the button for that box below, and pick its port in the list Chrome shows (it's usually called USB JTAG/serial debug unit or ESP32-S3). Then Connect.
  3. Choose Install. When it asks Erase device, leave the box unticked and click Next, then Install. Not erasing keeps the hub's target number, the relay's WiFi name, lane names and settings.
  4. Wait about a minute until it says the installation is complete. Unplug the box, switch it on and check it in the app (Settings › Firmware updates shows its build).
RelayThe firing-line relay (OVERSIGHT WiFi).
This browser can't flash over USB: use Chrome or Edge on a computer. Open this page over https to flash.
Target hubThe box behind the target, with the sensor jacks.
This browser can't flash over USB: use Chrome or Edge on a computer. Open this page over https to flash.

Installs the latest build.

If it won't connect

  • Try another USB-C cable or port: many cables only charge.
  • Close the OVERSIGHT app or any other page that might be using the port, then try again.
  • Still no port, or it stops at "Connecting": unscrew the box's lid, hold the BOOT button on the board, tap RESET, then let go of BOOT, and click the install button again. Press RESET once more when it's done.
  • Only tick Erase device if we ask you to: it wipes the hub number and relay settings, so a hub comes back as target 1 and the relay as OVERSIGHT (see the Range officer manual to set them again).
  • Still stuck? Email info@oversighttargets.com with what the installer says.